Redesign of Clove Dryer Simulation Machine Using Heat Waste of Radiator as the Heat Source

  • I Kadek Ervan Hadi Wiryanta Jurusan Teknik Mesin Politeknik Negeri Bali

Abstract

In this study, a redesign to a clove  dryer simulation tool using  exhaust heat from radiator as a source of heat energy has been done. The dryer  simulation tool consists of reservoir tank, a heater, a pump to circulate the water in the system, a radiator as a heat exchanger and a drying chamber with 2 shelves. The redesign stage is carried out by fixing the piping insulation system, changing the pipe and adding valve controls to vary the velocity of the fluid flow. Variations made are variations in the mass flow rate of 0.09 kg / s and 0.18 kg /s with a constant air flow rate of 1 m/s. The results of the analysis show that at a higher mass flow rate of 0.18 kg/s the average rate of heat transfer from the radiator air side is higher, which is around 3971.65 watts. The effectiveness of the radiator will also be higher at a higher mass flow rate, the average is 0.34 at a mass flow rate of 0.09 kg/s and 0.43 at a mass flow rate of 0.18 kg /s. For drying rates with a load of 2 kg of cloves with a higher flow rate of liquid will be faster, which is about 5 hours with a flow rate of  0.18 kg/s and 6.5 hours at a flow rate of 0.09 kg/s

Downloads

Download data is not yet available.
Published
Mar 30, 2019
How to Cite
WIRYANTA, I Kadek Ervan Hadi. Redesign of Clove Dryer Simulation Machine Using Heat Waste of Radiator as the Heat Source. Logic : Jurnal Rancang Bangun dan Teknologi, [S.l.], v. 19, n. 1, p. 7-13, mar. 2019. ISSN 2580-5649. Available at: <https://ojs.pnb.ac.id/index.php/LOGIC/article/view/1101>. Date accessed: 28 mar. 2024. doi: http://dx.doi.org/10.31940/logic.v19i1.1101.
Section
Articles